Petrol Engine Machinery
A. Requiring the Choke to stay on to run is usually a fuel delivery problem and you should clean or replace the Air Filter and Carburetor. For further info on this, please Click Here:
A. There are broadly two reasons for fuel leaking from the Carburetor. Either failed Seals or Gaskets. Or there is a Float Needle problem. We go into more if you Click Here:
A. On this type of engine, backfiring through the Carburetor is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and more info, Click Here:
A. There are initially three things to check, the low oil circuit, then the spark plug and ignition coil. For detailed instructions, Click Here:
Diesel Engine Machinery
A. On this type of engine, backfiring is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and further instructions, please Click Here:
A. These engines do not have a spark so this is often a fuel issue, for diagnostic steps, please Click Here:
A. This can depend on the colour of the smoke: black smoke is too much fuel/not enough air, so clean or replace the air filter then examine the injector; white smoke is usually water in the fuel, change the fuel and filters; blue smoke is a sign of burning oil, usually this is caused by failed valve seals or piston rings.
Electric Start Device
A. Generators recharge their own battery and the part that is responsible for this is called the Battery Charging Rectifier or Regulator and provides a steady voltage back to the battery while it is running, these parts are prone to overheating and failure, for please Click Here:
A. Firstly, whether this is an engine problem or electric start problem needs to be established. If the generator starts with the pull start, please see the link below, it will describe the different electric start circumstances and what to do. Click Here: