*Need Parts for a Generator? Click here to go to our Generator Division*

Four Hole Connector Blocks & Tab Connectors Set 2.8MM

No reviews yet Write a Review
د.ع6,565.21
Four Hole Connector Blocks & Tab Connectors Set 2.8MM
Condition:
New
Stock Locations: USA, CAN, UK, EU, AUS. Worldwide shipping available. View full description
د.ع6,565.21

Description

Four Hole Connector Blocks & Tab Connectors Set 2.8MM

 

Each set comes with:

1 x Male Connector block

1 x Female Connector block

Four x 1.5 mm Male and Female connector crimp tabs

(A Professional Crimping Tool and Wire Stripper is also available to purchase.)

These connectors are used on Small Engine machinery, ATV, and Motorcycles. They connect a series of wires together, making it easy to remove at the press of a lever. On the generator there are various sizes of these connector blocks.

Also good for replacing blocks that cannot be matched. If the existing connector block has 1.5mm tabs, just press the tab on the top of the brass tabs and pull the wire from the back. The wire will come out easily and fit. To fit to the new block just insert.

Extra Information

Petrol Engine Machinery

Q. Why does my engine need the choke on to stay running?

A. Requiring the Choke to stay on to run is usually a fuel delivery problem and you should clean or replace the Air Filter and Carburetor. For further info on this, please Click Here:

Q. How do I fix a fuel leak from my Carburetor?

A. There are broadly two reasons for fuel leaking from the Carburetor. Either failed Seals or Gaskets. Or there is a Float Needle problem. We go into more if you Click Here:

Q. Why is my engine backfiring through the Carburetor?

A. On this type of engine, backfiring through the Carburetor is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and more info, Click Here:

Q. I have no spark, what do I do?

A. There are initially three things to check, the low oil circuit, then the spark plug and ignition coil. For detailed instructions, Click Here:

Diesel Engine Machinery

Q. Why is my engine backfiring?

A. On this type of engine, backfiring is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and further instructions, please Click Here:

Q. My starter motor is spinning but the engine will not fire?

A. These engines do not have a spark so this is often a fuel issue, for diagnostic steps, please Click Here:

Q. Why is my generator producing excess smoke?

A. This can depend on the colour of the smoke: black smoke is too much fuel/not enough air, so clean or replace the air filter then examine the injector; white smoke is usually water in the fuel, change the fuel and filters; blue smoke is a sign of burning oil, usually this is caused by failed valve seals or piston rings.

Electric Start Device

Q. Why does my generator battery keep going flat?

A. Generators recharge their own battery and the part that is responsible for this is called the Battery Charging Rectifier or Regulator and provides a steady voltage back to the battery while it is running, these parts are prone to overheating and failure, for please Click Here:

Q. Why doesn’t my electric start work?

A. Firstly, whether this is an engine problem or electric start problem needs to be established. If the generator starts with the pull start, please see the link below, it will describe the different electric start circumstances and what to do. Click Here:

Back To Homepage