*Need Parts for a Generator? Click here to go to our Generator Division*

Handle Set

No reviews yet Write a Review

SKU:

Sale •

MSRP:

£93.98

£41.34

You save £52.64

Condition:: New

MSRP:

£93.98

£41.34

You save £52.64

Description

Replacement Handle Set for Small engine machinery with Wheel Kits.

(Full and retrofit Wheel kits available here)

Material - Toughened steel

Finish - Powder coated

Handles - Bonded extra thick rubber

Fixing Bolts - included

Max diameter of frame tube: 1 ³/₁₆" or 3 cm

*Drilling holes in the frame may be required if replacing a different design or this is a new fitting*

Roary the Repair Lion says:

We know what it is like trying to get your machinery wheeled around and the handles bend under the strain. So, instead of complaining, we thought we would do something about it!

We have had these handles manufactured to the highest standard. In fact, we believe they are the toughest on the market. We chose to go for extra thick steel to ensure they will handle the twisting, turning and lifting required on extremely rough terrain such as on building sites and farms.

We are so confident we provide a 5 year guarantee!

*Compatible Part

Extra Information

Petrol Engine Machinery

Q. Why does my engine need the choke on to stay running?

A. Requiring the Choke to stay on to run is usually a fuel delivery problem and you should clean or replace the Air Filter and Carburetor. For further info on this, please Click Here:

Q. How do I fix a fuel leak from my Carburetor?

A. There are broadly two reasons for fuel leaking from the Carburetor. Either failed Seals or Gaskets. Or there is a Float Needle problem. We go into more if you Click Here:

Q. Why is my engine backfiring through the Carburetor?

A. On this type of engine, backfiring through the Carburetor is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and more info, Click Here:

Q. I have no spark, what do I do?

A. There are initially three things to check, the low oil circuit, then the spark plug and ignition coil. For detailed instructions, Click Here:

Diesel Engine Machinery

Q. Why is my engine backfiring?

A. On this type of engine, backfiring is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and further instructions, please Click Here:

Q. My starter motor is spinning but the engine will not fire?

A. These engines do not have a spark so this is often a fuel issue, for diagnostic steps, please Click Here:

Q. Why is my generator producing excess smoke?

A. This can depend on the colour of the smoke: black smoke is too much fuel/not enough air, so clean or replace the air filter then examine the injector; white smoke is usually water in the fuel, change the fuel and filters; blue smoke is a sign of burning oil, usually this is caused by failed valve seals or piston rings.

Electric Start Device

Q. Why does my generator battery keep going flat?

A. Generators recharge their own battery and the part that is responsible for this is called the Battery Charging Rectifier or Regulator and provides a steady voltage back to the battery while it is running, these parts are prone to overheating and failure, for please Click Here:

Q. Why doesn’t my electric start work?

A. Firstly, whether this is an engine problem or electric start problem needs to be established. If the generator starts with the pull start, please see the link below, it will describe the different electric start circumstances and what to do. Click Here:

Back To Homepage