Oil Dipstick GHG3773735

No reviews yet Write a Review

SKU:

Sale • Save 50%

Was:

CAD $22.43

CAD $11.20

Condition:: New

Was:

CAD $22.43

CAD $11.20

Description

Replacement Dipstick made of non-corrosive plastic to withstand the rigours and heat from the engine.

Roary the Repair Lion says:

Dipsticks have a bad reputation... but we need them!

Not only do they keep the oil in your engine, they tell us how much oil we have and that is very important. Low oil can cause damage to engine parts and might result in your engine seizing altogether!

A small amount of oil can disappear in everyday running and will need topping up. If the oil goes low very quickly or the engine is putting out black smoke, this is an early sign that your Piston Rings need replacing. (See our piston rings page for advice on testing.)

So, show your dipstick the attention it deserves before you start your engine.

*Compatible part

We spend 1000's of hours every year providing Free Repair Advice. As you can imagine, this does not pay the bills!

If you would like to buy us a coffee to say thanks, we would really appreciate it!

Extra Information

Petrol Engine Machinery

Q. Why does my engine need the choke on to stay running?

A. Requiring the Choke to stay on to run is usually a fuel delivery problem and you should clean or replace the Air Filter and Carburetor. For further info on this, please Click Here:

Q. How do I fix a fuel leak from my Carburetor?

A. There are broadly two reasons for fuel leaking from the Carburetor. Either failed Seals or Gaskets. Or there is a Float Needle problem. We go into more if you Click Here:

Q. Why is my engine backfiring through the Carburetor?

A. On this type of engine, backfiring through the Carburetor is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and more info, Click Here:

Q. I have no spark, what do I do?

A. There are initially three things to check, the low oil circuit, then the spark plug and ignition coil. For detailed instructions, Click Here:

Diesel Engine Machinery

Q. Why is my engine backfiring?

A. On this type of engine, backfiring is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and further instructions, please Click Here:

Q. My starter motor is spinning but the engine will not fire?

A. These engines do not have a spark so this is often a fuel issue, for diagnostic steps, please Click Here:

Q. Why is my generator producing excess smoke?

A. This can depend on the colour of the smoke: black smoke is too much fuel/not enough air, so clean or replace the air filter then examine the injector; white smoke is usually water in the fuel, change the fuel and filters; blue smoke is a sign of burning oil, usually this is caused by failed valve seals or piston rings.

Electric Start Device

Q. Why does my generator battery keep going flat?

A. Generators recharge their own battery and the part that is responsible for this is called the Battery Charging Rectifier or Regulator and provides a steady voltage back to the battery while it is running, these parts are prone to overheating and failure, for please Click Here:

Q. Why doesn’t my electric start work?

A. Firstly, whether this is an engine problem or electric start problem needs to be established. If the generator starts with the pull start, please see the link below, it will describe the different electric start circumstances and what to do. Click Here:

Back To Homepage