*Need Parts for a Generator? Click here to go to our Generator Division*

Socket Driver Set 3 Piece

No reviews yet Write a Review

SKU:

Esc870.31

Condition:: New

Esc870.31

Description

Socket Driver Set comprising 3 Pieces made from Chrome vanadium steel.

Retaining ball for secure holding.

Drives 1/4", 3/8" and 1/2" sockets.

1/4" hex shank.

Roary the Repair Lion says:

Did you know??? Some Small Engine mechanics use these to start small engines.

1) Fit this to your electric drill
2) Determine the engine direction and then remove the recoil
3) Put socket that fits the flywheel nut onto the Driver set
4) Turn the engine with the drill as you quickly pull the drill towards you, removing the socket from the nut as it turns

The engine should start, and you saved a lot of effort!!

Beware - Be sure to pull the socket off quickly as you turn the engine, or the engine will fire up and turn the drill and socket with it. This can be dangerous!

If you are having issues starting your engine, check out our Free Interactive Repair Guide!

Extra Information

Petrol Engine Machinery

Q. Why does my engine need the choke on to stay running?

A. Requiring the Choke to stay on to run is usually a fuel delivery problem and you should clean or replace the Air Filter and Carburetor. For further info on this, please Click Here:

Q. How do I fix a fuel leak from my Carburetor?

A. There are broadly two reasons for fuel leaking from the Carburetor. Either failed Seals or Gaskets. Or there is a Float Needle problem. We go into more if you Click Here:

Q. Why is my engine backfiring through the Carburetor?

A. On this type of engine, backfiring through the Carburetor is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and more info, Click Here:

Q. I have no spark, what do I do?

A. There are initially three things to check, the low oil circuit, then the spark plug and ignition coil. For detailed instructions, Click Here:

Diesel Engine Machinery

Q. Why is my engine backfiring?

A. On this type of engine, backfiring is usually caused by problems in the Cylinder Head. Most commonly, the Valve Clearances need to be reset, or a Valve is stuck but this could also be other problems within the Cylinder Head so the parts need to be examined carefully. You can find a guide to resetting your Valve Clearances and further instructions, please Click Here:

Q. My starter motor is spinning but the engine will not fire?

A. These engines do not have a spark so this is often a fuel issue, for diagnostic steps, please Click Here:

Q. Why is my generator producing excess smoke?

A. This can depend on the colour of the smoke: black smoke is too much fuel/not enough air, so clean or replace the air filter then examine the injector; white smoke is usually water in the fuel, change the fuel and filters; blue smoke is a sign of burning oil, usually this is caused by failed valve seals or piston rings.

Electric Start Device

Q. Why does my generator battery keep going flat?

A. Generators recharge their own battery and the part that is responsible for this is called the Battery Charging Rectifier or Regulator and provides a steady voltage back to the battery while it is running, these parts are prone to overheating and failure, for please Click Here:

Q. Why doesn’t my electric start work?

A. Firstly, whether this is an engine problem or electric start problem needs to be established. If the generator starts with the pull start, please see the link below, it will describe the different electric start circumstances and what to do. Click Here:

Back To Homepage